2 Inch Tri-Clamp Weldless Bulkhead

  • Item #Z56
  • Price: $24.99
  • Part #
- +
Share |

This 2" KegLand Tri-Clover adapter adapts a a 44 to 47mm hole to accept a 2" Tri-Clover Fitting. Ideal for adding a Tri-Clover Extension to a distilling column. Includes two silicone washers to seal both sides. Fits the Mash & Boil and Brewzilla/Robobrew Distilling lids.

It requires a hole that is 1.62" in diameter, and it has an inner pass through diameter of 1.30".

(4)
Average rating 8 out of 10 ( based on 4 reviews )

Excellent product.

Review by Gus on 1/30/2020

Got these for my Chapman 7gal fermenters. I tried a couple of other bulkheads from different retailers and they were either to small and didnt cover the opening completely or too large and unusable. The double gaskets on this makes a tight seal and I am able to go from a tri-clamp blowoff tube to a co2 hose for pressurized transfer. Highly recommended!

Awesome Accessory

Review by Chuck on 2/28/2020

Solid well built I bought one to add a column to my kettle without welding and this works great the two gaskets make a nice tight seal. I highly recommend Williams brewing for all your needs fast shipping fair prices outstanding customer service what more could you ask for.

Inner diameter too small.

Review by Kevin Hannon on 7/4/2020

These are built well, I have no doubt they would seal well. The inner diameter is much smaller than a standard 2" tri-clamp fitting. They will not allow a 2" tri-clamp ripple heating element to pass through. I hope I can find some other place to use them. Other than that, Shipping was fast, things were well packed.

Nice Product

Review by BRYAN on 10/11/2020

Nice product, well constructed. It did work when i used it and it did seal, but the threaded portion is much smaller than 2" and was a bit difficult to center just right. But it did work for me.

Write a Review

Oct 28, 2020 by ROBERT LITT

Q: Fit an Anvil Foundry lid?

A: Yes, it fits the Anvil lid that will accept a distilling column (it fits any 43 to 47mm diameter hole).


Sep 14, 2020 by Robert

Q: Will this fit on a T500?

A: Yes, if the T500 includes a distilling lid with a 47mm hole in the center.


Dec 27, 2019 by Duane

Q: What is the inside diameter?

A: 1 and 5/16" in diameter


Sep 16, 2019 by Dan

Q: Will this fit on the Mash N Boil Fermentation Lid?

A: Yes


Aug 10, 2019 by Eric

Q: How long are the threads?

A: 1 inch long.


Ask a Question