This stainless fittings features a 1/4" male flare with a 1/4" hose barb. If the male flare is going into a metal contact female flare, you will also need a D87 concave washer to make this gas tight.
(1)
Average rating 10 out of 10
( based on 1
review )
Feb 23, 2023 by Tom
Q: I have a barbed quad-CO2 distributor and have 9/16” line terminating at a 1/4” MFL thread with barb. I’m looking to convert this line over to Duotight instead - can I use this piece instead of the existing MFL piece and then attach the DuoTight 8mm To Female Flare (#Z93)?
A: Without seeing your setup I can only confirm that item Z93 will screw onto item P24.

much needed item
I had to purchase this to modify the bottling gun i bought from NB earlier this year. the kit came with female 3pc swivel nuts on both sides. I cut one off and use this instead so i can adapt it to my kegerator co2 setup making it easy to setup on bottling day