Universal Copper Pot Still Dome

  • Item #Q99
  • Price: $199.99
- +

In stock, will ship on Friday, March 24

If you use a pot still to make spirits like bourbon, whiskey, scotch, or rum, this pure copper dome provides a large copper surface area which acts as a catalyst with the distillate vapor to remove unwanted sulphur compounds as well as helping enhance and concentrate the flavors and aroma. The result is a smoother, richer finished spirit.

This pure copper dome includes a 47mm (1.85") diameter hole and must be used with a condenser (Still Spirits Copper Condenser, KegLand Pot Still Condenser) to complete your home distilling rig. The copper is 1.2mm (.05") thick, and the entire dome weighs 2.68 pounds.

This is a universal fit dome, and fits the Mash & Boil (with lid clips), Brewzilla 3.1 35 Liter, Robobrew 3.0, 35 Liter,  Anvil Foundry 6.5 and 10.5, Still Spirits T500 Boiler,  and the Grainfather 35 Liter. Includes a silicone sealing washer for a positive seal to the lip of the boiler. 

Note: It will fit the Digiboil, but it is a very tight fit and will strain your clamps, so we do not really recommend it as far as a good fit for the Digiboil.

Average rating 10 out of 10 ( based on 1 review )

Heavy thick copper

Review by Charlie on 9/30/2021

I was pleased to find that this dome has much thicker copper than the Still Spirits Artisan Series alembic dome. Completely interchangeable. Lower price. Fits just about every 35L electric boiler.

Mar 14, 2023 by Bruce

Q: How do I clean this dome? After a couple of batches the inside is black. I have had little success getting it back to bare copper.

A: The easy way to clean your copper dome is to soak it in a solution of Star San (item A44) until it becomes shiny again. I would only soak it overnight, then rinse it well. There is no scrubbing needed.

Feb 19, 2023 by Vince

Q: Will this lid fit a Robobrw version 2?

A: That item (Q99) will fit the Robobrew, but item Q89 fits better and is $90.00 cheaper.

Nov 23, 2022 by Chris

Q: Does this fit a Brewzilla 35L version 4? Thanks

A: Yes, although the less expensive dome item Q89 also fits and does the same thing.

Jul 10, 2022 by DP

Q: Does this fit the Anvil Foundry 18 gallon?

A: No

Jan 29, 2022 by Mike

Q: Is there a way to attach simple line arm to this so you could use it with a separate thumper and worm?

A: You could use our item Z56 bulkhead to create a 2" tri clamp fitting on top of this, and then use 2" tri clamp tubing to make a lyne arm.

Ask a Question