Robobrew Gen 3.1.1 Upgrade Board Set 110 volt

  • Item #R50
  • Price: $59.99
  • Part #KL14199
- +

In stock, will ship on Monday, September 20

Share |

This set of two boards (one power, one display) will upgrade your Robobrew Gen 3 to the latest Brewzilla 3.1.1 software. These boards feature more reliable power relays, and will fix a Gen 3 Robobrew that has a heating element that has failed. This only fits the Gen 3, and does not fit earlier models.  Only fits 110 volt versions of the Gen 3 Robobrew, these do not fit the 220 volt version. This does not fit older Robobrews (prior to Gen 3).


NOTICE: Both boards must be installed at once, which takes a little doing, as some wires have to be rerouted to different board terminals. This should be done by a qualified electrician if you do not have experience in electrical wiring. Please read the instruction sheet below before ordering to see if this is what you need.

Click HERE for installation instructions.

Write a Review

Mar 15, 2021 by steven kimball

Q: I have a brewzilla 3.1 Do I need to replace both cards to upgrade to 3.1.1? The relay card currently installed in my system looks just like the one shown in the upgrade,

A: Only the display board if you have a 3.1


Nov 09, 2020 by Gary Hayes

Q: Can this be used to replace damaged boards in a 35L Brewzilla 3.1.1

A: Yes, this fit Brewzilla 3.1.1 units


Ask a Question