This set of two boards (one power, one display) will upgrade your Robobrew Gen 3 to the latest Brewzilla 3.1.1 software. These boards feature more reliable power relays, and will fix a Gen 3 Robobrew that has a heating element that has failed. This only fits the Gen 3, and does not fit earlier models. Only fits 110 volt versions of the Gen 3 Robobrew, these do not fit the 220 volt version. This does not fit older Robobrews (prior to Gen 3).
NOTICE: Both boards must be installed at once, which takes a little doing, as some wires have to be rerouted to different board terminals. This should be done by a qualified electrician if you do not have experience in electrical wiring. Please read the instruction sheet below before ordering to see if this is what you need.
Click HERE for installation instructions.
Jun 05, 2025 by Vernon
Q: Can this be adjusted from celcius to farenheit?
A: The Robobrew 3.1 when working properly can be switched from celcius to farenheit. This board set cannot be switched, unless it is installed in a working 3.1 Robobrew or Brewzilla.
Feb 07, 2022 by George
Q: Please tell me that some will be ordered soon. I have only brewed 12 times on this system and already need to replace the 3.0.
A: We intend to have them again, but it will be a few months. Best thing to do is to put your email address in the notify section and you will get an email as soon as they come in.
Jan 24, 2022 by Shane
Q: Hello, any idea when more of these will be available? My circuit board burned out, and I haven't been able to find a replacement in stock anywhere. Thank you.
A: We do not have any of the circuit boards for the Brewzilla 3.1.1on our next order. We are sorry but we do not have a back in stock date at this time.
Mar 15, 2021 by steven kimball
Q: I have a brewzilla 3.1 Do I need to replace both cards to upgrade to 3.1.1? The relay card currently installed in my system looks just like the one shown in the upgrade,
A: Only the display board if you have a 3.1
Nov 09, 2020 by Gary Hayes
Q: Can this be used to replace damaged boards in a 35L Brewzilla 3.1.1
A: Yes, this fit Brewzilla 3.1.1 units
Waiting for this for a while
My Robobrew was dead with the original board, so waited about a year for this to be in stock. Install was easy, ran one brew and it worked fine.