Cannular Pro Splash Guard

  • Item #C41
  • Price: $44.99
- +

In stock, will ship on Saturday, April 1

This splash guard is made of 304 grade stainless hardware and strong polycarbonate plastic. Attaches to the Cannular Pro so you can fill the cans almost to the brim to reduce dissolved oxygen, and not worry as much about beer droplets spraying when you spin the can. 

Also useful if you use your Cannular in a commercial environment such as a bar, where filling is done next to staff and other equipment you do not want to get beer spray on. Ships dissasembled, assembles with a metric allen key.

For assembly instructions, click here.   

Note: This does not fit the manual Cannular. 


(1)
Average rating 8 out of 10 ( based on 1 review )

Works well, but too short.

Review by Greg Eytcheson on 6/8/2021

It was a massive pain to install because the screw holes don’t line up exactly with the holes in the Cannular Pro. After finally getting them forced in, I canned some beer using the 16.9 oz Cannular cans. The shield is about an inch too short to extend past the spin/splatter that comes from the bottom of the can. We ended up using a strip of duct tape around the bottom to provide a skirt and make it long enough. It’s a lot better than nothing, but the design could be better.

Ask a Question