Fits all regulators and our Two Line Adapter. This nickel plated brass valve features a male 1/4" NPT on one end, and a 1/4" hose barb. Includes a built-in check valve to prevent beer inflow from the gas line back into the regulator.
Mar 25, 2019 by JD
Q: Can the barb be replaced with a 1/4 NPT x 1/4 MFL adapter?
A: No you can't remove and replace it. We are looking into getting some with a flair fitting, but we won't have them in stock until mid summer.
Make sure you order the correct valves!
I ordered three of these valves to split airlines to run three taps out of a 2 regulator system. after purchasing these valves and a Y, I found that the gas lines on my set up are not 1/4 inch. After much research using 1/4 inch gas lines can cause problems in dispensing. Since this was my mistake, I kept the valves but had to buy 3/8 valves from a different supplier. (Cost me another $40) These are cheap Chinese valves, but so were the ones I had to replace them with. It looks like we are limited to a Chinese source for this application.
Great Valve
I have a few lines with check valves seperate from the shut off. these extra pieces get in the way. having it all in one is a huge help.
shut off valve
Pros: The valve works great and is well made. The check valve is nice to have to prevent beer from flowing back into the CO2 tank when you shake the keg and force carbonate.
Cons: none