Item #: P59
Our Price: $24.99
In Stock, Will Ship On 01/24/2020.
  Shut Off Valve W/Check And 1/4" Hose Barb (+ $8.99)


This gas distributor (with a machined aluminum billet body) featurs the home brew standard ¼ inlet and outlet hose barbs, so they will fit ¼ interior diameter gas tubing (unlike most distributors which feature 5/16 barbs for commercial beer gas hose).

Great for distributing gas from a single regulator to 3 kegs. Each dispensing valve has a check valve to prevent beer from backing up into the distributor.  On the aluminum billet body, the end opposite the inlet barb is plugged with a ¼" male NPT plug. This can be removed and another brass valve or part like our Q87, D16, or D69 (at left) installed. 7.5" long.


Average Rating:
(based on 2 reviews)

Showing 2 Reviews:

Review and Rate this Item
by Doug
on 7/28/2019
from Oregon
Nice manifold
This works much better than the homemade one I had and discarded long ago. I like that each dispensing valve has a check valve.
by Browneye
on 2/20/2019
from So-Cal
Watch Your Line Size
Unbeknownst to me these are 1/4" nipples and everything else for Co2 is 5/16". So my gas lines were way too loose. I replaced the feed nipple with 5/16 so I could use standard gas line from the regulator to this, then 3/16" beer line to my kegs. 
It worked out fine, and this thing is perfect for charging 3 kegs off one regulator. 
I have a two-port regulator, so one feeds this for serving kegs, and the other for force-carbing kegs. It was an easy way to charge 4 kegs with a two-port regulator. 
Just beware your nipple and gas line sizes. 
Review and Rate this Item
6/11/2018 10:42:27 AM
Can the fittings be removed to flip around the orientation?
It's possible but will be difficult since the valves have a thread lock glue on them to seal them in to the body of the manifold.  
Ask a Question

    Email A Friend

    Send this product to a friend...