(53)
Average rating 9.28301886792453 out of 10 ( based on 53 reviews )

Diamond In The Rough!

Review by Logan on 1/28/2017

After nearly a year of being boiled, frozen, banged against things, and 199 gallons of beer run through it this little beast runs like the day I got it. Pump plugged once from a 4oz flame out addition of pellet hops dumped right over my dip tube(ID10T ERR). Whirlpools 10 gal batches through cfc no problem but I would consider going with a higher flow rate if you plan to brew larger batches.

Excellent Pump

Review by Daniel Rosen on 2/9/2017

So far so good. The pump has worked without issues for my past 4 brews, and for cleaning duties as well (recirculating PBW). It is not loud, does not get hot, and i figure it's running non stop for 2 hours each brew day. I did get the stainless head, but I have done 2 with the plastic, 2 with the stainless, and both worked fine. The only con, and ONLY con, is that I wish it was sold with an extra oring. But all in all, very good quality, very good pumping volume, fits perfectly in my setup.

Plastics impeller head

Review by Edgar on 2/10/2017

When I received this item, I realized that I should have ordered the stainless steal pump head at the same time. After asking the service department what type of thread the pump had on it, picked up the fittings to put it into use this morning. After fooling around about 30 minutes I thought that I had my quich disconnect coupling threaded on straight so I put a wrench on it, less then half a turn and the out side snapped like it wasn't even there. I'd love to supply pics to this rating, I hope the motor lasts longer.

MARK II WORT PUMP

Review by Dave on 2/13/2017

Great pump and price. I think it outperformed the Chugger Pump.

Great Pump

Review by Gil on 2/17/2017

When I saw the price I decided to try one out. I own two big name pumps that were noisy, and finicky. These worked so well I now own two of them, I have always bought the stainless head. - very quiet almost silent - sealed, which gives me a piece of mind when they sit in a very wet environment - tend to prime better in my experience - tend to clean easier in my experience, every now and then my old pump heads had to be taken apart, I have not had to do this with these - 30% less cost even with the stainless head

Write a Review