Item #: I51
Our Price: $14.99
Quantity:
 
In Stock, Will Ship On 09/22/2019.
Share |

Description 

Made from 304 stainless to last a lifetime. For the beer side (usually marked OUT) of a ball-lock equipped keg. This fitting features a 1/4" male threaded flare fitting, to fit any 1/4" female threaded flare attachment. The white nylon ring around the base indicates that it is a gas fitting (beer fittings are black). 2.25" high.

Reviews

Average Rating:
(based on 5 reviews)

Showing 5 Reviews:

Review and Rate this Item
RatingReviewerReview
by Phil
on 11/1/2017
from Alabama
low profile
With these i can stack kegs in my converted refrigerator kegerator .
by Tim Q
on 7/3/2017
from Everett, WA
Really, watch the video
 With a smooth click the fitting lands home. I'm hooked!

 At 10 minutes 2 seconds, the Keg King video is a bit long but you'll learn so much about  ball lock fittings. 
by PJ
on 1/30/2017
from Las Vegas
Well Built
Hey look around on the internet. I found these elsewhere but they were a lot more expensive. These are very well made, solid and will probably out last me. You can't beat this price for SOLID stainless steel. Basically only twice as much as plastic and they will last forever.
by Dennis
on 12/17/2016
from PA
Excellent Quality
The fit / finish on these connections are A-1. They are made to last a lifetime! Plus they are a little shorter than their plastic counterparts and the right angle connection is a big improvement. Strongly recommend!.
by Dave
on 10/21/2016
from Pittsburgh, PA
Short and Stubby (but that's a good thing!)
Very good solid quality...it's pricey, but I know for sure this will hold up...over time I may upgrade my whole setup.

The main thing though:  It's a good 1/8 inch shorter than the stubbiest of any other plastic/nylon ball lock connector that I've ever found!  This, plus the fact that the outlet comes straight out of the side at 90 degrees (instead of up and out at around 45 degrees like pretty much all connectors) means that is has a solid 3/8ths to 1/2 inch lower clearance.  If you have a tight setup (I'm in an old commercial kegerator where the clearance below the condenser unit makes it impossible to slide a ball lock all the way under with the connector on) this connector is a must!
Review and Rate this Item
QuestionAnswer
Benjamin
1/8/2018 4:33:56 PM
Is there a "swivel nut" available for this coupler that will fit 5/16" inside diameter gas tubing?
Yes, our item D08. Make sure you use a D87 Concave washer with this to seal.
SS
10/24/2017 5:43:29 AM
How much above the rubber handles of a ball lock does this fitting stick out?
1 1/8" inch above.
Ask a Question

    Email A Friend

    Send this product to a friend...