Item #: I52
Our Price: $14.99
Quantity:
 
In Stock, Will Ship On 11/14/2018.
Share |

Description 

Made from the highest quality stainless steel to last a lifetime. For the beer side (usually marked OUT) of a ball-lock equipped keg. This fitting features a 1/4" male threaded flare fitting, to fit any 1/4" female threaded flare attachment. The black ring around the base indicates that it is a beer fitting (gas fittings are grey). 2.25" high.

Reviews

Average Rating:
(based on 5 reviews)

Showing 5 Reviews:

Review and Rate this Item
RatingReviewerReview
by Phil
on 11/1/2017
from Alabama
low profile
With these i can stack kegs in my converted refrigerator kegerator.  These are solid, with little "give," so when it's on, it's on. Depresses the poppet like it's supposed to and beer flows.  My previous plastic connectors appeared to be locked down, but beer would not flow.
by Tim Q
on 7/3/2017
from Everett, WA
Watch their video...
 With a smooth click the fitting lands home. I'm hooked!

 At 10 minutes 2 seconds, the Keg King video is a bit long but you'll learn so much about  ball lock fittings. 

by PJ
on 1/30/2017
from Las Vegas
Well Built
Hey look around on the internet. I found these elsewhere but they were a lot more expensive. These are very well made, solid and will probably out last me. You can't beat this price for SOLID stainless steel. Basically only twice as much as plastic and they will last forever.
by Charles
on 11/9/2016
from Minneapolis
Perfect height
It was perfect height to add Perlick faucet to 5 gallon keg, inside a KEEZER with no collar.
by Dave
on 10/21/2016
from Pittsburgh
Short and Stubby (but that's a good thing!)
Very good solid quality...it's pricey, but I know for sure this will hold up...over time I may upgrade my whole setup.

The main thing though:  It's a good 1/8 inch shorter than the stubbiest of any other plastic/nylon ball lock connector that I've ever found!  This, plus the fact that the outlet comes straight out of the side at 90 degrees (instead of up and out at around 45 degrees like pretty much all connectors) means that is has a solid 3/8ths to 1/2 inch lower clearance.  If you have a tight setup (I'm in an old commercial kegerator where the clearance below the condenser unit makes it impossible to slide a ball lock all the way under with the connector on) this connector is a must!
Review and Rate this Item
QuestionAnswer
Brian
11/6/2018 5:06:21 AM
Are these 100% stainless steel including the internal ball bearings?
Yes
Mike
7/13/2017 10:25:52 AM
Can it be disassembled for cleaning? Is it made in China?
Yes, they can be disassembled although most people just flush them with hot water. They are made in China.
Ask a Question

    Email A Friend

    Send this product to a friend...