• Italian Fruit Crusher (Actual Shipping Item)
  • This shows the rollers with the stainless knives protruding
  • This shows the crusher upside down

click on thumbnail to zoom
Item #: I99
Our Price: $249.99
Quantity:
 
In Stock, Will Ship On 05/23/2019.
Share |

Description 

This Italian made fruit crusher (it will crush everything from stemmed grapes to apples and pears) fits on top of a bin or bucket with its four rails, and features a 304 grade stainless hopper that is 14" by 16" in size at the top. Unlike our Italian Grape Crusher, this Fruit Crusher features stainless steel blades embedded in the crushing rollers that pull fruit into the roller gap to insure adequate crushing.

Put fruit into the hopper and turn the crank to crush before pressing the pulp with a fruit press. You will need to secure the rails when crushing harder fruit like apples to prevent the crusher from sliding around too much on top of your catch bin.

The rollers are 2.5" wide, and 6" long, and turn on a 3/4" (18mm) diameter hollow steel shaft.  The rails are 32" long, and 12" wide. Height from the bottom of the rails to the top of the hopper (not including the hand crank) is 12".

 

Reviews

Average Rating:
(based on 1 review)

Showing 1 Review:

Review and Rate this Item
RatingReviewerReview
by Wissam Gharib
on 9/15/2017
from West Virginia
great after some modification
the crusher is great so far however the handle and nuts that come with it are useless and will not stay on - a minor modification with two 10.5 mm locking nuts on the ends and two washers on wither side of the wooden handle did the trick.  works great so far - cut the apples in half for better grabbing power
Review and Rate this Item
QuestionAnswer
Duane Hopper
10/19/2018 7:39:48 PM
Since made in Italy, I am sure that the input shaft is metric What is its diameter in millimeters, please? Thank you in advance.
18mm hollow shaft
Steve Miller
4/28/2018 7:24:40 AM
Where is this crusher manufactured?
This is made in Italy.
Vince Mitchell
10/1/2017 3:31:02 AM
Can a 1/2" drill be attached to this crusher?
The roller shaft is slightly over 1/2" diameter, so a 1/2 drill chuck will not fit this shaft. 
Ask a Question

    Email A Friend

    Send this product to a friend...