Boil with electricity instead of gas! This electric BoilCoil kit includes a heater element with all necessary mounting hardware and a 12ft power cable. The unique BoilCoil electric heating element features relatively low density wattage, so wort does not burn on the coil, while still getting the pot to a rolling boil. This 240 volt model heats faster than the 110 volt model, and is more efficient (although a 240 volt dishwasher or electric dryer type circuit is required).
The cable is 10ga for 240V models and is made with a high quality very flexible cable. Each cord has a factory installed plug on each end, so the product is truly plug-and-brew. The heater end of the cable is terminated with a custom molded plug. The other end is terminated with a twist-lock connector: L6-30P for 240V models, and a L5-20P for 120V models. Uses 3750 watts, so this requires a dedicated 20/30 amp circuit. For safety this 240 volt model must be plugged into a GFCI rated at 20/30 amps.
This installs in a 10 gallon Blichmann Boilermaker by drilling two 5/8" holes with the included template. Then just put the ends of the coil through the hole, and secure with the included mounting bolts, washers, and plug box (which goes on the outside of the pot). This does not include an on/off switch, so you turn it off by unplugging it. This should never be run dry, or left plugged in for periods exceeding the length of your boil.
Drop shipped from Indiana, allow 2-3 weeks for delivery. No air shipment.