Taprite Gas Regulator

  • Item #D02
  • Price: $64.99
  • Part #
Currently Sold Out
Share |

Our two-gauge U.S. made Taprite regulator provides a reading of keg dispensing pressure, as well as an accurate indication of cylinder gas level. By turning the red center knob, you can adjust the dispensing pressure from 0 – 50 PSI. Pull the red knob out to rotate and adjust, and then press it back in to lock your setting. Features a 2" diameter rubber diaphragm for precise low pressure adjustments.

Threaded 1/4” outlet fits our D03 Gas Connector or D66 Barbed Adapter (no need to adapt your ¼" gas tubing to fit the 5/16" wide hose barb found on other beer regulators). Includes a safety relief valve, one way check valve, and integral rubber gas cylinder washer.

(3)
Average rating 10 out of 10 ( based on 3 reviews )

Good value

Review by Tom-S on 4/25/2009

Pros: The knob works very well, much easier than having a set screw and lock nut. Lowest-priced regulator of this type I could find.

Cons: None. I'm completely satisfied with this product.

worth the cost

Review by Matt on 4/9/2014

I bought this after my last "economy" regulator broke. This gauge is much better in quality and the knob is so much easier to work with. Worth every penny.

Nice regulator

Review by Steve T on 7/28/2019

Well made and reliable. Pressure adjustment is smooth and easy. I appreciate the integrated shut-off and 1/4" flare fitting.

Write a Review

Sep 16, 2018 by Jeff Vandewinckel

Q: Can I swap the low pressure gage with the connector to the tank? As pictured above the regulator faces the operator when the tank points to the left. I would like the tank pointing to the right.

A: Very difficult because Taprite assembles the gauges with a Locktite type glue, and they are very hard to remove. It is possible to swap the high pressure gauge on the left with the inlet. just very hard to remove the parts without damaging them.


Ask a Question