Item #: D11
Our Price: $3.99
In Stock, Will Ship On 07/30/2015.

Share |


Unlike standard lid O rings which have a .280" cross section, our exclusive Overside O Ring has a slightly larger (.310") diameter, and is molded from softer rubber, for a more positive seal at low dispensing pressures. An ideal fix for an older keg with a leaky lid, or for any keg that needs to be pressurized before filling to achieve an airtight seal. Fits all brands of kegs, pin-lock or ball-lock, with a 3 by 3.5” clamp down oval lid. 

Best for older lids, as new lids when installed on older kegs tend to have tighter tolerances, and a standard O ring (our part P92) works fine. Note: Pictured lid is not included. 


Average Rating:
(based on 15 reviews)

Showing 1 - 5 of 15 Reviews:

by William
on 9/5/2014
I forgot about these....
Now that I'm brewing more and trying to ferment in kegs, these are a must because of the low pressures... Works good. Ordering 4 more now.
by Steven
on 3/13/2014
I've been trying to fix a leaky keg lid for the longest time and nothing seemed to work until I found this part and gave it a shot. So glad I did! It was an amazingly easy fix! Wish I had known about it sooner.
by Dan
on 1/27/2014
Nice job
Works as advertised. I would not hesitate to buy again if needed.
by Bret
on 10/21/2013
Works well, wish it was silicone
I prefer silicon rings but couldn't find one thick enough to seal a keg I need sealed without pressure. This worked.
by marc
on 10/8/2013
Oversized O-ring
This was the best $6 fix every. I was ready to use the Corneykeg for parts when I stumbled upon this gem. My Corneykeg opening had seen better days. It wasn't even straight. I had beat on it with hammers, bent and rebent the edges and never could fix the leak. Shazam this did it for $6. Worth it's weight in gold.
Review and Rate this Item

Email A Friend

Send this product to a friend...